Neovin 1.5HP Water Pump Automatic Pressure Controller
Share:
Neovin 1.5HP Water Pump Automatic Pressure Controller
Contact Us
Brand: NEOVIN
Category: Hose & Plumbing
Quantity:
Using OMRON contact relays that semiconductor is utilized, which enables high-speed and high-frequency operation.
Neovin controller is used to automatically control the functioning of electric water pumps. It can guarantee the optimum control of electric pumps used in plumbing systems. Being an intelligent mix of hydraulic and electronic engineering, the control maintains both pressure and flow and controls the operation of the pump automatically. It needs no pressure tank as in the traditional systems. There are no plenum chambers to recharge and no irritating variation in pressure and in flow at the point of use. No adjustment or maintenance is required. It is absolutely dependable, durable and simple to install.
**Functioning**
The unit is programmed to perform all the pump control operations automatically. When particular operational breakdowns occur, such as water failure, obstruction of the suction pipe, etc, the unit recognizes the breakdown and a red LED Failure lights up, at the same time a stop signal is sent to the pump to prevent damage caused by it working in the absence of water. After rectifying the cause of the failure the system to be restarted by pressing the Reset button.
**Specifications**
Model P86H1
Rated Voltage 240V
Max. Current 10A
Frequency 50Hz
Max. Power 1.1kW
Starting Pressure 1.5bar
Max. Pressure 1Mpa (10bar)
Max. Operating Temperature 60C
Joint Screw 1inch (25mm)
Protection Grade IP65
This controller comes pre-wired and plug top
Warranty 12 months
Neovin controller is used to automatically control the functioning of electric water pumps. It can guarantee the optimum control of electric pumps used in plumbing systems. Being an intelligent mix of hydraulic and electronic engineering, the control maintains both pressure and flow and controls the operation of the pump automatically. It needs no pressure tank as in the traditional systems. There are no plenum chambers to recharge and no irritating variation in pressure and in flow at the point of use. No adjustment or maintenance is required. It is absolutely dependable, durable and simple to install.
**Functioning**
The unit is programmed to perform all the pump control operations automatically. When particular operational breakdowns occur, such as water failure, obstruction of the suction pipe, etc, the unit recognizes the breakdown and a red LED Failure lights up, at the same time a stop signal is sent to the pump to prevent damage caused by it working in the absence of water. After rectifying the cause of the failure the system to be restarted by pressing the Reset button.
**Specifications**
Model P86H1
Rated Voltage 240V
Max. Current 10A
Frequency 50Hz
Max. Power 1.1kW
Starting Pressure 1.5bar
Max. Pressure 1Mpa (10bar)
Max. Operating Temperature 60C
Joint Screw 1inch (25mm)
Protection Grade IP65
This controller comes pre-wired and plug top
Warranty 12 months
Inquiry - Neovin 1.5HP Water Pump Automatic Pressure Controller
